1、 適用材質：金屬、電鍍、氧化鋁、電解板、鋁塑板、噴（烤）漆、噴塑、PA塑料尼龍、電木、玻璃鋼、密胺等。

2、 產品特性：半光、免烘烤、耐酒精、耐沖壓。

3、 稀釋劑：本公司B-03稀釋劑或783慢幹稀釋劑。

4、 固化劑：本產品為單組份，如有特殊要求也可選擇添加固化劑增加附著力及墨層抗性。

5、 調配：充份攪拌後取所需用量進行調配使用，雙組份先按比例添加固化劑攪拌均勻，然後再添加稀釋劑稀釋到合適粘度進行印刷；添加固化劑後的超過使用時限會產生粘稠膠化現象，請及時清洗網版，並棄用，不可回收。

6、 網版及刮膠：適合80T-140T（200目-350目）聚脂網紗，聚氨脂PU油性刮膠。

7、 幹燥條件及時間：本產品可以常溫幹燥，也可以烘烤快速幹燥，建議幹燥溫度及時間為25℃/24小時，60℃/40分鐘，80℃/30分鐘，100℃/20分鐘。Screen printing ink

Application materials: metal, electroplating, alumina, electrolytic plate, aluminum plate, spray (baked) paint, spray, PA nylon plastic, bakelite, glass steel, melamine and other.

2, product characteristics: semi light, non baking, alcohol, resistance to stamping.

3, thinner: the c o mpany‘s B-03 thinner or 783 slow dry diluent.

4, curing agent: This product for single c o mponent ink, such as special requirements can also choose to add curing agent increased adhesion and ink layer resistance.

5, ink deployment: fully mixing after taking amount redeployment, t w o-c o mponent ink first ac c ording to the proportion of adding curing agent and stirring evenly, and then add the diluted with a diluent to the appropriate viscosity printing; add curing agent after the ink over the use of time will produce the phenomenon of viscous gel, please timely cleaning screen, and abandoned ink and can not be recovered.

6, screen and frictioning: for 80T-140T (200 -350 mesh) polyester mesh, polyurethane PU oily frictioning.

7, drying conditions and time: the product can be dry at room temperature, can also be baked fast drying, rec o mmended drying temperature and time of 25 /24 hours, 60 /40 minutes, 80 degrees /30 minutes, 100 degrees /20 minutes.